Other information:
System Operation
Headlamps
System Diagram
Low Beams
The BCM
monitors the headlamp switch position by sending voltage signals on
multiple circuits to the headlamp switch. There is one circuit for each
headlamp switch position. At any given time, one of the signal circuits
is switched to ground to indicate the headlamp switch position.
If the BCM detects..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the push pin, release the clips and remove the RH floor console side trim panel.
Disconnect the electrical connector and remove the evaporator temperature sensor.
Installation
To install, rev..