Ford Fiesta: Evaporative Emissions - 1.6L EcoBoost (132kW/180PS) – Sigma / Fuel Tank Pressure Sensor and Tube. Removal and Installation

Ford Fiesta 2014 - 2019 Service Manual / Engine / Evaporative Emissions - 1.6L EcoBoost (132kW/180PS) – Sigma / Fuel Tank Pressure Sensor and Tube. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).

Disconnect the battery.
Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).

1. Disconnect the quick release coupling and disconnect the electrical connector.
  Refer to: Quick Release Coupling (310-00B Fuel System - General Information - 1.6L EcoBoost (132kW/180PS) – Sigma, General Procedures).

Installation

To install, reverse the removal procedure.

Evaporative Emission Canister Ventilation Filter. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the EVAP canister. Refer to: Evaporative Emission Canister (303-13B Evaporative Emissions - 1...

Electronic Engine Controls - 1.6L EcoBoost (132kW/180PS) – Sigma

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Parking Aid. Diagnosis and Testing

DTC Charts BCM DTC Chart DTC Description Action B1088:83 LIN Bus "B": Value of Signal Protection Calculation Incorrect GO to Pinpoint Test F B1088:88 LIN Bus "B": Bus Off GO to Pinpoint Test F B115E:08 Camera Mo..

Ford Fiesta 2014 - 2019 Service Manual: Module Configuration - System Operation and Component Description. Description and Operation

System Operation Programmable Module Installation (PMI) PMI is a scan tool process which configures settings in a new module. Data used for the PMI process is automatically downloaded from the original module and stored when a scan tool session is started. If this data cannot be retrieved from the module being replaced, the scan tool may prompt for As-Built data entry or displ..

Front Strut and Spring Assembly. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: This step is only necessary when installing a new component to the left-hand side.

Remove the nuts and position aside the remote brake fluid reservoir.
Torque: 62 lb.in (7 Nm)

Remove the strut and spring assembly upper mount nuts.
Torque: 22 lb.ft (30 Nm)