Other information:
Special Tool(s) /
General Equipment
Feeler Gauge
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Use a Straightedge that is calibrated by the
manufacturer to be flat within 0.005 mm (0.0002 in) per running foot of
length, such as Snap-On® GA438A or equivalent. For example, if the
Straightedge is 61 cm (24 in) long,..
Removal
WARNING:
Always disconnect the battery ground cable at the battery
before disconnecting the starter motor battery terminal lead. If a tool
is shorted at the starter motor battery terminal, the tool can quickly
heat enough to cause a skin burn. Failure to follow this instruction may
result in serious personal injury.
NOTE:
Removal steps in this procedure may ..