Ford Fiesta: Tire Pressure Monitoring System (TPMS) / Tire Pressure Monitoring System (TPMS) - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Suspension / Tire Pressure Monitoring System (TPMS) / Tire Pressure Monitoring System (TPMS) - Overview. Description and Operation

Overview

The BCM monitors the tire pressure in the 4 road tires with tire pressure sensors that communicate the tire pressure via radio signals to the BCM . The tire pressure sensors are battery operated and mounted to the valve stems. All of the controlling software for the TPMS is contained in the BCM . The IPC illuminates the TPMS warning indicator and the message center displays a message when a fault is present or when the tire pressure falls below the low pressure limit.

Tire Pressure Monitoring System (TPMS) - Component Location. Description and Operation

Tire Pressure Monitoring System (TPMS) - System Operation and Component Description. Description and Operation

System Operation System Diagram Item Description 1 MS-CAN 2 IPC 3 BCM 4 Message center display 5 TPMS warning indicator 6 LH front TPMS sensor 7 RH front TPMS sensor 8 LH rear TPMS sensor 9 RH rear TPMS sensor ..

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Front Door Window Regulator Motor. Removal and Installation

Removal NOTE: LH side shown, RH side similar. NOTE: Removal steps in this procedure may contain installation details. Remove the front door trim panel. Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Remove the front door window regulator and motor. Disconnect the front door window ..

Ford Fiesta 2014 - 2019 Service Manual: Muffler and Tailpipe. Removal and Installation

Special Tool(s) / General Equipment Air Body Saw Removal NOTICE: The production muffler and tailpipe assembly is one-piece construction. The service muffler and tailpipe is 2-piece construction. It is necessary to cut the production exhaust system to enable the service section(s) to be fitted. Before cutting any part of the exhaust system, check that the position ..

Ride Height Measurement. General Procedures

Special Tool(s) / General Equipment

Surface Gauge

Check

Ride Height Measurement - Front

NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

Ride height = 2-3
Measurement 2
Measurement 3
Use the General Equipment: Surface Gauge