Ford Fiesta: Body and Paint / Wipers and Washers

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Wipers and Washers

Radio Frequency (RF) Receiver. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Materials Name Specification 3M™ Super-Fast Repair Adhesive04747 - Removal Remove the headliner...

Wipers and Washers - Overview. Description and Operation

Overview The windshield wiper/washer system is activated by the wiper/washer switch (also known as the steering column multifunction switch RH )...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Quick Release Coupling. General Procedures

Disconnect NOTICE: When reusing liquid or vapor tube connections, make sure to use compressed air to remove any foreign material from the connector retaining clip area before separating from the tube or damage to the tube or connector retaining clip may occur...

Ford Fiesta 2014 - 2019 Service Manual: Evaporator Temperature Sensor. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the push pin, release the clips and remove the RH floor console side trim panel. Disconnect the electrical connector and remove the evaporator temperature sensor...

Component Bleeding. General Procedures

Special Tool(s) / General Equipment

Master Cylinder Bleeding Set

Bleeding

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

Master Cylinder

NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system.

NOTE: Make sure the area around the master cylinder cap is clean and free of foreign material.

Remove the brake fluid reservoir cap.