Ford Fiesta Manuals

Ford Fiesta: Wipers and Washers / Windshield Washer Pump. Removal and Installation

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Wipers and Washers / Windshield Washer Pump. Removal and Installation

Special Tool(s) / General Equipment

Fluid Container

Removal

  1. Remove LH fender splash shield.
    Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation).
  1. NOTE: Be prepared to collect escaping fluid.

    Disconnect the washer pump electrical connector and remove the windshield washer pump.
    Use the General Equipment: Fluid Container

Installation

  1. To install, reverse the removal procedure.

    Rear Window Wiper Motor. Removal and Installation

    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the nut and the rear wiper pivot arm. Torque: 133 lb...

    Windshield Washer Reservoir. Removal and Installation

    Removal Remove LH fender splash shield. Refer to: Fender Splash Shield (501-02 Front End Body Panels, Removal and Installation). Disconnect the electrical connector and remove the bolt...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Engine Cooling System Draining, Vacuum Filling and Bleeding. General Procedures


    Special Tool(s) / General Equipment ROB75240Coolant/Battery Refractometer (Fahrenheit) Hose Clamp Remover/Installer Fluid Container Cooling System Vacuum Tester and Refiller Materials Name Specification Motorcraft® Orange Prediluted Antifreeze/CoolantVC-3DIL-B WSS-M97B44-D2  Motorcraft® Orange Concentrated Antifreeze/Co..

    Ford Fiesta 2014 - 2019 Service Manual: Electric Booster Heater. Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the heater core and evaporator core housing - vehicles with: EMTC and remove the heater core and evaporator core housing - vehicles with: EATC . Refer to: Heater Core and Evaporator Core Housing - Vehicles With: Electronic Manual Temperature Control (EMTC) (412-00 Climate Control Sys..

    Categories

    Ride Height Measurement. General Procedures

    Special Tool(s) / General Equipment

    Surface Gauge

    Check

    Ride Height Measurement - Front

    NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

    Ride height = 2-3
    Measurement 2
    Measurement 3
    Use the General Equipment: Surface Gauge

    read more

    Copyright © 2026 www.fofiesta7.com