Ford Fiesta Manuals

Ford Fiesta: Steering System / Steering Column

Tie Rod. Removal and Installation

Special Tool(s) / General Equipment Tie Rod End Remover Tie Rod Remover and Installer Boot Clamp Pliers Materials Name Specification Motorcraft® Premium Long-Life GreaseXG-1-E1 ESA-M1C75-B  Removal NOTICE: When servicing inner tie rods, install a new bellows boot and clamps...

Steering Column - Overview. Description and Operation

The steering column is the mechanical linkage between the steering wheel and the steering gear and also contains the PSCM , motor and steering sensor, which are used for providing power assist...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: External Controls - Overview. Description and Operation


Overview The manual transmission external controls consists of the following: Gearshift Cables shift cable selector cable Gearshift lever Gearshift lever knob and boot Transmission shift lever Transmission selector lever System Operation The manual transmission is controlled by a floor-mounted gearshift lever..

Ford Fiesta 2014 - 2019 Service Manual: Catalytic Converter. Removal and Installation


Special Tool(s) / General Equipment Cable Ties Removal NOTE: Exhaust fasteners are of a torque prevailing design. Use only new fasteners with the same part number as the original. Torque values must be used as specified during reassembly to make sure of correct retention of exhaust components. NOTE: Removal steps in this procedure may contain installation d..

Categories

Brake Master Cylinder. Removal and Installation

Removal

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

Remove the battery tray.
Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Disconnect the vacuum tube from the brake booster and detach the routing clip.

read more

Copyright © 2026 www.fofiesta7.com