Ford Fiesta: Steering Column / Steering Wheel Cover Repair. General Procedures
Materials
| Name |
Specification |
Motorcraft® Instant Gel Adhesive TA-19-C |
WSS-M2G401-B5
|
Repair
-
NOTE:
If re-adhering leather to the front side of the
steering wheel only, it will not be necessary to remove the steering
wheel. Steering wheel removal is necessary only when repairing loose
leather on the backside of the steering wheel.
If necessary, remove the steering wheel.
Refer to: Steering Wheel (211-04 Steering Column, Removal and Installation).
-
Position the loose leather out of the way.
-
NOTE:
Avoid sanding the grooved area, if applicable.
Sand steering wheel structure intended to be adhered.
-
NOTE:
Avoid applying adhesive in the grooved area, if applicable
Apply the specified adhesive evenly over the wheel area to be adhered.
Material: Motorcraft® Instant Gel Adhesive
/ TA-19-C
(WSS-M2G401-B5)
-
Position the loose leather back into the original position.
-
NOTE:
The adhesive should be completely set after 5 minutes. Do not pull on the repair area.
Smooth the leather and tuck in for neat appearance.
-
Apply pressure (for at least 30 seconds) until the leather is bonded to the wheel.
-
If removed, install the steering wheel.
Refer to: Steering Wheel (211-04 Steering Column, Removal and Installation).
The steering column is the mechanical linkage between the steering
wheel and the steering gear and also contains the PSCM , motor and
steering sensor, which are used for providing power assist...
Special Tool(s) /
General Equipment
Grinder
Removal
NOTICE:
To prevent damage to the clockspring, make sure the front wheels are in the straight-ahead position...
Other information:
DTC Charts
DTC Chart: Anti-Lock Brake System (ABS) Module
Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...
B1404:11, B1404:12, B1404:13 and B1404:1A
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM continuously monitors the driver side airbag circuits for the following faults:
Resistance out of range
Unexpected voltage
Short to ground
Faulted driver side airbag
If a..