Ford Fiesta: Steering Column / Steering Column - Overview. Description and Operation
The steering column is the mechanical linkage between the steering
wheel and the steering gear and also contains the PSCM , motor and
steering sensor, which are used for providing power assist. For
additional information about the PSCM , motor and steering sensor,
For
additional information, refer to: Power Steering - System Operation and
Component Description (211-02 Power Steering, Description and
Operation).
Steering Wheel Cover Repair. General Procedures
Materials
Name
Specification
Motorcraft® Instant Gel AdhesiveTA-19-C
WSS-M2G401-B5
Repair
NOTE:
If re-adhering leather to the front side of the
steering wheel only, it will not be necessary to remove the steering
wheel...
Other information:
Ford Fiesta 2014 - 2019 Service Manual: Front Drive Halfshafts. Diagnosis and Testing
Inspection and Verification Verify the customer concern. Visually inspect for obvious signs of mechanical or electrical damage. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step If the cause is not visually evident, verify the symptom and refer to the Symptom Chart...
Ford Fiesta 2014 - 2019 Service Manual: Information and Entertainment System - Component Location. Description and Operation
Item Description 1 6.5-inch (165 mm) FDIM 2 FCIM (with Sony®) 3 FCIM (without Sony®) 4 Front AM / FM /HD Radio® (if equipped) antenna coaxial cable and satellite radio/ GPS splitter/cable assembly 5 Microphone (located in the headliner) 6 RHF door midwoofer speaker ( LHF also shown) (without Sony®) ..
Categories
- Manuals Home
- Ford Fiesta Service Manual (2014 - 2019)
- Front Strut and Spring Assembly. Removal and Installation
- Camshafts. Removal and Installation
- Engine Cooling - 1.6L EcoBoost (132kW/180PS) – Sigma
- Engine
- Brake System
Component Bleeding. General Procedures
Special Tool(s) / General Equipment
Master Cylinder Bleeding SetBleeding
NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
Master Cylinder
NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system.
NOTE: Make sure the area around the master cylinder cap is clean and free of foreign material.
Remove the brake fluid reservoir cap.