Ford Fiesta: Rear View Mirrors / Rear View Mirrors - Overview. Description and Operation
Overview - Exterior, Power
The power mirrors allow the LH and RH
exterior mirror glass position to be adjusted electronically by the
driver. The exterior mirror glass position is controlled by the exterior
mirror control switch. Selecting the LH or RH position of the exterior
mirror selection switch determines which power mirror glass to control.
Overview - Exterior, Heated
The exterior mirrors are available with heated mirror glass to remove frost, snow, ice and condensation.
Overview - Interior
The
interior rear view mirror may be equipped with a manual or auto-dimming
feature to control the reflectance of the interior rear view mirror
glass. The manual dimming feature is controlled by the driver with the
lever at the bottom of the mirror. The auto-dimming feature
electronically darkens the interior rear view mirror glass when bright
lights (glare) are detected from behind the vehicle during nighttime
conditions.
System Operation
Rear View Mirrors - Exterior, Power
The LH and RH exterior mirror glass movement is controlled by the
exterior mirror control switch and the LH and RH exterior mirror motors...
Other information:
B0052:11, B0052:12, B0052:13 and B0052:1D
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM monitors the passenger safety belt buckle switch circuits for the following faults:
Open circuit
Short to voltage
Short to ground
Current out of range
Faulted passeng..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Recover the refrigerant.
Refer to: Air Conditioning (A/C) System Recovery,
Evacuation and Charging (412-00 Climate Control System - General
Information)
.
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lif..
Categories
Removal
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
NOTE:
Removal steps in this procedure may contain installation details.
All vehicles
Remove the battery tray.
Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma
(414-01 Battery, Mounting and Cables, Removal and Installation).
Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Disconnect the vacuum tube from the brake booster and detach the routing clip.
read more