Ford Fiesta: Generator and Regulator / Specifications
Ford Fiesta 2014 - 2019 Service Manual / Battery and Charging System / Generator and Regulator / Specifications
General Specifications
| Item | Specification |
|---|---|
| Generator - 1.0L EcoBoost engine | |
| Generator pulley ratio | 2.62:1 |
| Rating | 97 amps at 750 rpm (min) to 166 amps at 2,300 rpm (max) |
| Voltage regulator type | Electronic internal with generator |
| Generator - 1.6L EcoBoost engine | |
| Generator pulley ratio | 2.62:1 |
| Rating | 79 amps at 750 rpm (min) to 156 amps at 2,300 rpm (max) |
| Voltage regulator type | Electronic internal with generator |
| Generator - 1.6L Duratec-16V Ti-VCT engine | |
| Generator pulley ratio | 2.62:1 |
| Rating | 81 amps at 750 rpm (min) to 130 amps at 2,300 rpm (max) |
| Voltage regulator type | Electronic internal with generator |
Generator - 1.6L EcoBoost (132kW/180PS) – Sigma. Removal and Installation
Removal
WARNING:
Before beginning any service procedure in this
manual, refer to health and safety warnings in section 100-00 General
Information...
Other information:
Ford Fiesta 2014 - 2019 Service Manual: Front Door Side Impact Sensor. Removal and Installation
Removal WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash. Follow all notes and steps carefully. Failure to follow step instructions may result in incorrect operation of the restraint system and increases the risk of serious personal injury or death in a crash...
Ford Fiesta 2014 - 2019 Service Manual: Electric Booster Heater. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the heater core and evaporator core housing - vehicles with: EMTC and remove the heater core and evaporator core housing - vehicles with: EATC ...
Categories
- Manuals Home
- Ford Fiesta Service Manual (2014 - 2019)
- Service Information
- Clutch - 6-Speed Manual Transmission – B6
- Front Suspension
- Valve Clearance Adjustment. General Procedures
- Maintenance Schedules
Rear Wheel Speed Sensor. Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
Remove the retainer and pull the rear splash shield outward.
Disconnect the electrical connector and detach the wiring retainer.
Copyright © 2025 www.fofiesta7.com