Ford Fiesta: Glass, Frames and Mechanisms / Front Door Window Glass. Removal and Installation
Removal
All vehicles
NOTE:
LH side shown, RH side similar.
-
Remove the front door trim panel.
Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the front door window glass weatherstrip.
Refer to: Front Door Window Glass Weatherstrip (501-11 Glass, Frames and Mechanisms, Removal and Installation).
Vehicles with manual windows
-
Lower the front door window glass.
-
Partially install the window crank handle.
-
Lower the front door window glass.
Vehicles with power windows
-
Lower the front door window glass.
-
Connect the front door window control switch.
-
Lower the front door window glass.
All vehicles
-
Remove the inner belt moulding.
-
Remove the adhesive tape covers.
-
Remove the retainers.
-
Remove the front door window glass.
-
Rotate the front door window glass 45 degrees clockwise.
-
Remove the front door window glass.
Installation
-
To install, reverse the removal procedure.
-
If the door is equipped with one touch up/down, carry out the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Removal
NOTE:
LH side shown, RH side similar.
Remove the rear door window control switch.
Remove the rear door window control switch from the door trim panel...
Removal
NOTE:
LH side shown, RH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front door trim panel...
Other information:
The B6 6-speed manual transmission is a fully synchronized transmission including reverse gear.
The 1st and 2nd gears are triple cone synchronized. The 3rd, 4th, 5th, 6th and reverse gears are single cone synchronized.
The
function of the transmission is to move the vehicle from a rest
position to motion...
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the instrument panel lower trim panel.
Refer to: Instrument Panel Lower Trim Panel (501-12 Instrument Panel and Console, Removal and Installation)...
Categories
Special Tool(s) /
General Equipment
Master Cylinder Bleeding Set
Bleeding
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
Master Cylinder
NOTE:
When a new brake master cylinder has been installed, it
should be primed to prevent air from entering the system.
NOTE:
Make sure the area around the master cylinder cap is clean and free of foreign material.
Remove the brake fluid reservoir cap.
read more