Ford Fiesta Manuals

Ford Fiesta: Handles, Locks, Latches and Entry Systems / Keyless Entry Rear Antenna. Removal and Installation

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Handles, Locks, Latches and Entry Systems / Keyless Entry Rear Antenna. Removal and Installation

Removal

  1. Remove the rear bumper cover.
    Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation).

  1. Remove the keyless entry rear antenna.
    • Disconnect the keyless entry rear antenna electrical connector.
    • Remove the retainers.
    • Remove the keyless entry rear antenna.

Installation

  1. To install, reverse the removal procedure.

    Exterior Rear Door Handle Reinforcement. Removal and Installation

    Removal NOTE: LH side shown, RH side similar. Remove the rear door latch. Refer to: Rear Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation)...

    Liftgate Latch. Removal and Installation

    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the liftgate trim panel. Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Airbag and Seatbelt Pretensioner Supplemental Restraint System (SRS) - Component Location. Description and Operation


    Item Description 1 LH and RH side air curtains 2 Driver side airbag 3 Passenger side airbag 4 Passenger airbag 5 Driver airbag 6 Driver lower airbag Item Description 1 C-pillar side impact sensors 2 Driver and passenger safety belt buckles (includes buckle..

    Ford Fiesta 2014 - 2019 Service Manual: Evaporative Emission Canister. Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. With the vehicle in NEUTRAL, position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation). Disconnect the negative battery cable. Refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General P..

    Categories

    Ride Height Measurement. General Procedures

    Special Tool(s) / General Equipment

    Surface Gauge

    Check

    Ride Height Measurement - Front

    NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

    Ride height = 2-3
    Measurement 2
    Measurement 3
    Use the General Equipment: Surface Gauge

    read more

    Copyright © 2026 www.fofiesta7.com