Ford Fiesta: Electronic Feature Group / Cruise Control
Removal
Remove the rear seat cushion.
Refer to: Rear Seat Cushion (501-10 Seating, Removal and Installation).
Disconnect the electrical connector, remove the strips and the PATS rear antenna...
Overview
The cruise control system is controlled by the PCM and the IPC
. The cruise control system is designed to maintain a selected vehicle
speed between 30 km/h (18 mph) and the maximum limited vehicle speed...
Other information:
Check
NOTE:
If there is a concern with one of the following components
and Bezel Diagnostics cannot be accessed, obtain the module part number
or ESN by referencing the label attached to the module.
Inoperative ACM
Inoperative (blank or does not power on) display unit (non-touchscreen display or touchscreen display)
Inoperative FCIM or radio control panel
..
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Refer to: Air Conditioning (A/C) System Recovery,
Evacuation and Charging (412-00 Climate Control System - General
Information)
.
Remove the retainers and the under side air deflector.
Rotate the accessory drive belt t..
Categories
Special Tool(s) /
General Equipment
Master Cylinder Bleeding Set
Bleeding
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
Master Cylinder
NOTE:
When a new brake master cylinder has been installed, it
should be primed to prevent air from entering the system.
NOTE:
Make sure the area around the master cylinder cap is clean and free of foreign material.
Remove the brake fluid reservoir cap.
read more