Ford Fiesta Manuals

Ford Fiesta: Cruise Control / Cruise Control - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Electronic Feature Group / Cruise Control / Cruise Control - Overview. Description and Operation

Overview

The cruise control system is controlled by the PCM and the IPC . The cruise control system is designed to maintain a selected vehicle speed between 30 km/h (18 mph) and the maximum limited vehicle speed. When a MyKey® restricted key is in use and max speed limiter is turned on, vehicle speed is limited. The maximum vehicle speed can be set to 105 km/h (65 mph), 113 km/h (70 mph), 121 km/h (75 mph) , or 129 km/h (80 mph).

The cruise control system is controlled by the steering wheel mounted switches (ON/OFF, SET+, SET-, and CAN/RES), brake pedal inputs and CPP switch (manual transmission). The cruise control switches are hard-wired to the IPC . The IPC sends a HS-CAN message to the PCM to control the cruise control system. The clockspring provides the electrical interface between the steering column wiring and the cruise control switches in the steering wheel.

    Cruise Control

    ..

    Cruise Control - System Operation and Component Description. Description and Operation

    System Diagram Item Description 1 IPC 2 Clutch pedal switch 3 Cruise control switches 4 Accelerator pedal 5 BPP switch 6 Deactivator switch 7 PCM 8 ABS module 9 Stoplamp switch 10 HS-CAN System Operation Network Message Chart ..

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Passive Anti-Theft System (PATS) Front Antenna. Removal and Installation


    Removal Remove the selector lever assembly and gearshift lever. Refer to: Selector Lever Assembly (307-05 Automatic Transmission External Controls - 6-Speed PowerShift Transmission – DPS6/6DCT250, Removal and Installation). Refer to: Gearshift Lever (308-06 Manual Transmission External Controls - 5-Speed Manual Transmission – B5/IB5/6-Speed Manual Transmission – B6, Re..

    Ford Fiesta 2014 - 2019 Service Manual: Front Fog Lamp Adjustment. General Procedures


    Adjustment NOTE: Horizontal aim is not required for this vehicle and is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming. Before starting the fog lamp assembly adjustment: Check the tire inflation. Make sure there are no other loads in the vehicle other than a half tank of fuel...

    Categories

    Rear Wheel Speed Sensor. Removal and Installation

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    Remove the retainer and pull the rear splash shield outward.
    Disconnect the electrical connector and detach the wiring retainer.

    read more

    Copyright © 2026 www.fofiesta7.com