Ford Fiesta Manuals

Ford Fiesta: Seating / Seats - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Seating / Seats - Overview. Description and Operation

Overview

Seating - Heated

This system allows independent heating of each front seat. The components of the system consist of the following:

  • seat heater mats (located on the seat cushion and backrest)
  • heated seat relays (located in the CJB )
  • heated seat switches (located on the instrument panel)
  • BCM

    Specifications

    SPECIFICATIONS   Torque Specifications Description Nm lb-ft lb-in Rear seat backrest hinge bolts a 40 30 - Rear seat backrest striker bolts 25 18 - aDiscard and install new...

    Seats - System Operation and Component Description. Description and Operation

    System Operation Heated Seat Operation The heated seat system only operates when the engine is running. When the driver or passenger heated seat control switch (located on the instrument panel) is activated, it supplies a momentary ground signal to the BCM ...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Microphone. Removal and Installation


    Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: If the microphone is removed from the headliner, a new microphone must be installed. Headliner Microphone Pry the microphone bezel from the headliner metal mounting bracket and remove the microphone from the headliner by grasping the microphone pigtail...

    Ford Fiesta 2014 - 2019 Service Manual: Input Shaft. Disassembly and Assembly of Subassemblies


    Special Tool(s) / General Equipment 205-199 (T83T-3132-A1) Installer, Spindle/Axle ShaftT83-4000-ATKIT-1983-FTKIT-1983-FLMTKIT-1983-FX 205-D015 (D80L-630-4) Step Plate 211-014Remover, Steering Wheel 307-679Installer, Countershaft Needle BearingTKIT-2010D-FLMTKIT-2010D-ROW Hydraulic Press Hot Air Gun Bearing Separator ..

    Categories

    Ride Height Measurement. General Procedures

    Special Tool(s) / General Equipment

    Surface Gauge

    Check

    Ride Height Measurement - Front

    NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

    Ride height = 2-3
    Measurement 2
    Measurement 3
    Use the General Equipment: Surface Gauge

    read more

    Copyright © 2026 www.fofiesta7.com