Ford Fiesta: Multifunction Electronic Modules / Remote Function Actuator (RFA) Module. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: If equipped with push button start the keys need to be programmed into the new RFA module during ignition off. Once the push button start keys have been programmed into the new RFA module, the ignition must be changed to the ON mode in order to carry out the PATS parameter reset procedure with the RFA module and the PCM .

1. Remove the passenger front seat.
   Refer to: Front Seat (501-10 Seating, Removal and Installation).
   

1. 
   Remove the RFA module.
   
   • Remove the bolts and the RFA module and bracket assembly.
     Torque: 89 lb.in (10 Nm)
   • Release the wiring harness retainers and disconnect the electrical connectors.
     
   • Remove the bolts and the RFA module from the RFA module bracket assembly.
     

Installation

1. To install, reverse the removal procedure.
   

1. NOTE: This step is only necessary when installing a new component.

   • Program the passive keys to the RFA module.
     Refer to: Key Programming Using Diagnostic Equipment (419-01C Passive Anti-Theft System (PATS) - Vehicles With: Keyless Entry and Push Button Start, General Procedures).
     
   • Carry out the PATS parameter reset.
     Refer to: Passive Anti-Theft System (PATS) Parameter Reset (419-01C Passive Anti-Theft System (PATS) - Vehicles With: Keyless Entry and Push Button Start, General Procedures).