Ford Fiesta: Instrument Panel and Interior Switches Illumination / Instrument Panel and Interior Switches Illumination - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Instrumentation and Warning Systems / Instrument Panel and Interior Switches Illumination / Instrument Panel and Interior Switches Illumination - Overview. Description and Operation

Overview

Dimmable Backlighting

Dimmable illumination provides backlighting to all buttons during day time. It also provides backlighting to switches and control components when the headlamps or parking lamps are on. The level of intensity is adjusted by pressing the instrument panel dimmer switch up to increase intensity or down to decrease intensity.

Non-dimmable Backlighting

Non-dimmable illumination provides backlighting to the window switches with the ignition ON or OFF while the ignition relay is energized.

Instrument Panel and Interior Switches Illumination

Instrument Panel and Interior Switches Illumination - System Operation and Component Description. Description and Operation

System Operation System Diagram Item Description 1 MS-CAN 2 Infotainment Controller Area Network (I-CAN) 3 LIN 4 FCIM 5 IPC 6 APIM 7 FCDIM 8 Seat heater switch, passenger 9 Seat heater switch, driver 10 BCM ..

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Exterior Mirror. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: Not all procedure steps are required for some components. Mirror Assembly Remove the front door speaker. Refer to: Front Door Speaker (415-00A Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC, Removal and Installation). Refer to: Fro..

Ford Fiesta 2014 - 2019 Service Manual: Rear Knock Sensor (KS). Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Release the hose clamp and disconnect the hose from the crankcase vent oil separator. Disconnect the KS electrical connector. NOTE: Note the position of the component before removal. The KS must be..

Brake Master Cylinder. Removal and Installation

Removal

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

Remove the battery tray.
Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Disconnect the vacuum tube from the brake booster and detach the routing clip.