Ford Fiesta: Handles, Locks, Latches and Entry Systems / Hood Latch Release Handle. Removal and Installation

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Handles, Locks, Latches and Entry Systems / Hood Latch Release Handle. Removal and Installation

Removal

Depress the hood latch release handle retaining tab and pull the hood latch release handle.

Disconnect the hood release cable from the hood latch release handle.

Installation

To install, reverse the removal procedure.

Hood Latch. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the bolts and the hood latch from the core support...

Interior Front Door Handle. Removal and Installation

Removal NOTE: LH side shown, RH side similar. Remove the front door trim panel. Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Auxiliary Power Point. Removal and Installation

Special Tool(s) / General Equipment 501-039Remover, Power Point SocketTKIT-1998-FLMTKIT-1998-LM Removal Open the power point cover. Use Special Service Tool: 501-039 Remover, Power Point Socket. Remove the power point socket...

Ford Fiesta 2014 - 2019 Service Manual: Air Conditioning (A/C) System Recovery, Evacuation and Charging. General Procedures

Special Tool(s) / General Equipment Air Conditioning Service Unit Refrigerant Identification Equipment Recovery NOTICE: Use an A/C refrigerant analyzer before recovering any of the vehicle's A/C refrigerant. Failure to do so puts the shop's bulk refrigerant at risk of contamination...

Component Bleeding. General Procedures

Special Tool(s) / General Equipment

Master Cylinder Bleeding Set

Bleeding

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

Master Cylinder

NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system.

NOTE: Make sure the area around the master cylinder cap is clean and free of foreign material.

Remove the brake fluid reservoir cap.