Ford Fiesta: Fuel Charging and Controls - 1.6L EcoBoost (132kW/180PS) – Sigma / Fuel Charging and Controls. Diagnosis and Testing

Ford Fiesta 2014 - 2019 Service Manual / Engine / Fuel Charging and Controls - 1.6L EcoBoost (132kW/180PS) – Sigma / Fuel Charging and Controls. Diagnosis and Testing

General Equipment

Ford diagnostic equipment

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these,
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).

For PCM DTC ,
REFER to: Electronic Engine Controls (303-14B Electronic Engine Controls - 1.6L EcoBoost (132kW/180PS) – Sigma, Diagnosis and Testing).
MIL Code List.

For driveability symptoms without DTC , Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. section 3 Symptom Charts.

Fuel Charging and Controls. Description and Operation

System Operation For System Operation, Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 1 Description and Operation...

Fuel Injectors. Removal and Installation

Removal and Installation Refer to: Fuel Rail (303-04B Fuel Charging and Controls - 1.6L EcoBoost (132kW/180PS) – Sigma, Removal and Installation)...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Engine Cooling System Draining, Vacuum Filling and Bleeding. General Procedures

Special Tool(s) / General Equipment ROB75240Coolant/Battery Refractometer (Fahrenheit) Hose Clamp Remover/Installer Fluid Container Cooling System Vacuum Tester and Refiller Materials Name Specification Motorcraft® Orange Prediluted Antifreeze/CoolantVC-3DIL-B WSS-M97B44-D2 Motorcraft® Orange Concentrated Antifreeze/Co..

Ford Fiesta 2014 - 2019 Service Manual: Headlamp Assembly. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Disconnect the headlamp electrical connector. Remove the bolt and remove the headlamp assembly. Torque: 44 lb.in (5 Nm) Installation To install, reverse the removal procedure. ..

Rear Wheel Speed Sensor. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the retainer and pull the rear splash shield outward.

Disconnect the electrical connector and detach the wiring retainer.