Ford Fiesta Manuals

Ford Fiesta: Rear Disc Brake / Brake Disc Shield. Removal and Installation

Ford Fiesta 2014 - 2019 Service Manual / Brake System / Rear Disc Brake / Brake Disc Shield. Removal and Installation

Removal

  1. Refer to: Wheel Knuckle - 1.6L EcoBoost (132kW/180PS) - Sigma (204-02) .

Installation

  1. To install, reverse the removal procedure.

    Brake Disc. Removal and Installation

    Materials Name Specification Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake FluidPM-20 WSS-M6C65-A2  Motorcraft® Metal Brake Parts CleanerPM-4-A, PM-4-B, APM-4-C -  Removal NOTE: Removal steps in this procedure may contain installation details...

    Brake Pads. Removal and Installation

    Special Tool(s) / General Equipment Brake Caliper Piston Retractor Materials Name Specification Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake FluidPM-20 WSS-M6C65-A2  Removal NOTE: Removal steps in this procedure may contain installation details...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Fluorescent Dye Leak Detection. General Procedures


    Special Tool(s) / General Equipment UV Leak Detector Electronic Leak Detector Leak detection Vehicles with air conditioning Review next note for important refrigerant system dye information. NOTE: Fluorescent refrigerant system dye is added to the refrigerant system at the factory to assist in refrigerant system leak diagnosis using a ..

    Ford Fiesta 2014 - 2019 Service Manual: Climate Control System - Vehicles With: Electronic Automatic Temperature Control (EATC) - System Operation and Component Description. Description and Operation


    System Diagram System Diagram Item Description 1 Evaporator temperature sensor 2 Ambient air temperature (AAT) sensor 3 IPC 4 PCM 5 A/C pressure transducer 6 A/C compressor clutch 7 Center register air discharge temperature sensor 8 Footwell air discharge temperat..

    Categories

    Ride Height Measurement. General Procedures

    Special Tool(s) / General Equipment

    Surface Gauge

    Check

    Ride Height Measurement - Front

    NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

    Ride height = 2-3
    Measurement 2
    Measurement 3
    Use the General Equipment: Surface Gauge

    read more

    Copyright © 2026 www.fofiesta7.com