Ford Fiesta: Multifunction Electronic Modules / Transport and Factory Mode Deactivation. General Procedures

Ford Fiesta 2014 - 2019 Service Manual / Electronic Feature Group / Multifunction Electronic Modules / Transport and Factory Mode Deactivation. General Procedures

Deactivation

Place the ignition in the OFF position.

Verify the battery is fully charged.
Refer to: Battery (414-01 Battery, Mounting and Cables, Diagnosis and Testing).

Place the ignition in the ON position.

NOTE: Steps 5 and 6 must be carried out within 10 seconds.
Press and release the brake pedal 5 times.

Press and release the hazard switch 2 times (on, off).

Place the ignition in the OFF position.

Remote Function Actuator (RFA) Module. Diagnosis and Testing

DTC Chart: Remote Function Actuator (RFA) Module Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...

Body Control Module (BCM). Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: This step is only necessary when installing a new component...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Keyless Entry Rear Antenna. Removal and Installation

Removal Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation). Remove the keyless entry rear antenna. Disconnect the keyless entry rear antenna electrical connector...

Ford Fiesta 2014 - 2019 Service Manual: Clutch Pedal. Removal and Installation

Removal WARNING: Carefully read cautionary information on product label. For emergency medical information seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available...

Rear Wheel Speed Sensor. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the retainer and pull the rear splash shield outward.

Disconnect the electrical connector and detach the wiring retainer.