Ford Fiesta: Starting System - 1.6L EcoBoost (132kW/180PS) – Sigma / Starting System - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Engine / Starting System - 1.6L EcoBoost (132kW/180PS) – Sigma / Starting System - Overview. Description and Operation

Starting System

The starting system controls the cranking of the engine. The starter motor is enabled by the starter relay when the relay is activated by the PCM . The PCM receives inputs from the Ignition switch - push button start, BCM and CPP switch before activating the starter relay to initiate cranking of the engine.

Specifications

General Specifications Item Specification Normal engine cranking speed (Average) 200-250 RPM Starting circuit maximum voltage drop (Engine at normal operating temperature) (Average) 0...

Starting System - System Operation and Component Description. Description and Operation

System Diagram Item Description 1 PCM 2 Starter Relay 3 Starter Motor 4 BCM 5 Ignition Switch - Push Button Start 6 RFA 7 Clutch Pedal Switch 8 Brake Switch System Operation Network Message Chart Module Network Input Messages Powertrain Control Module (PCM) ..

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Engine Cooling. Diagnosis and Testing

Materials Name Specification Motorcraft® Orange Prediluted Antifreeze/CoolantVC-3DIL-B WSS-M97B44-D2 Motorcraft® Orange Concentrated Antifreeze/CoolantVC-3-B WSS-M97B44-D Special Tool(s) 3-Way HD Antifreeze Coolant Test Kit328-2050-62291 or equivalent Coolant/Battery Refractometer300-ROB75240 or equi..

Ford Fiesta 2014 - 2019 Service Manual: Headliner - Lowering - 4-Door. Removal and Installation

On both sides. Remove the retainers and the sun visor. On both sides. Remove the retainer and the sun visor clip. On both sides, remove the A-pillar trim panel. Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). On both sides, rem..

Component Bleeding. General Procedures

Special Tool(s) / General Equipment

Master Cylinder Bleeding Set

Bleeding

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

Master Cylinder

NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system.

NOTE: Make sure the area around the master cylinder cap is clean and free of foreign material.

Remove the brake fluid reservoir cap.