Ford Fiesta: Battery, Mounting and Cables / Specifications

Ford Fiesta 2014 - 2019 Service Manual / Battery and Charging System / Battery, Mounting and Cables / Specifications

General Specifications

1.0L EcoBoost vehicles
Item	Specification
Voltage	12 Volts
Battery amps rating	56 amp/hr
Cold Cranking Amps (CCA) measured at -18 C (-0.4 F)	590 Cold Cranking Amps (CCA)

1.6L Duratec-16V Ti-VCT and 1.6L EcoBoost vehicles
Item	Specification
Voltage	12 Volts
Battery amps rating	48 amp/hr
Cold Cranking Amps (CCA) measured at -18 C (-0.4 F)	500 Cold Cranking Amps (CCA)

Battery, Mounting and Cables

Battery and Cables - Overview. Description and Operation

Overview The battery and cable system consists of the following: Battery Battery tray High current BJB Negative battery cable, with a battery monitoring sensor (if equipped with 1...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Gearshift Cable Adjustment - 5-Speed Manual Transmission – B5/IB5. General Procedures

Adjustment Position the gearshift in N position. With the vehicle in N , position it on a hoist. Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation)...

Ford Fiesta 2014 - 2019 Service Manual: Rear Wheel Speed Sensor - 1.6L EcoBoost (132kW/180PS) – Sigma. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the wheel and tire. Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation). Remove the retainer and pull the rear splash shield outward...

Brake Master Cylinder. Removal and Installation

Removal

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

Remove the battery tray.
Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Disconnect the vacuum tube from the brake booster and detach the routing clip.