Ford Fiesta: Climate Control System - General Information / Specifications

Ford Fiesta 2014 - 2019 Service Manual / Climate Control System / Climate Control System - General Information / Specifications

Lubricants, Fluids, Sealers and Adhesives

	Specifications
Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D	WSH-M1C231-B
Motorcraft® R-134a Refrigerant / YN-19 (US); CYN-19-R (Canada); MYN-19 (Mexico)	WSH-M17B19-A
Motorcraft® A/C System Flushing Solvent / YN-23	—
Motorcraft® A/C Cooling Coil Coating / YN-29	—

Capacities


Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D	1.0L EcoBoost 4.1 fl oz (121 ml)
Motorcraft® PAG Refrigerant Compressor Oil / YN-12-D	All others 5.1 fl oz (151 ml)
Motorcraft® R-134a Refrigerant / YN-19 (US); CYN-19-R (Canada); MYN-19 (Mexico)	1.0L and 1.6L EcoBoost 24 oz (0.68 kg)
	1.6L Duratec – 16V Ti-VCT 21 oz (0.59 kg)

A/C Compressor Clutch Air Gap

	mm
A/C compressor clutch air gap	0.30 — 0.60

Climate Control System - General Information

Climate Control System - Vehicles With: Electronic Automatic Temperature Control (EATC) - Component Location. Description and Operation

Item Description 1 HVAC module 2 Footwell air discharge temperature sensor 3 In-vehicle temperature sensor 4 Center register air discharge temperature sensor 5 Sunload sensor Item Description 1 Evaporator 2 Heater core 3 Blower motor Item ..

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Reversing Lamp Switch. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Section 100-02. Disconnect the reversing lamp switch electrical connector. Remove the reversing lamp switch. ..

Ford Fiesta 2014 - 2019 Service Manual: Pinpoint Test - DTC: G. Diagnosis and Testing

B0052:11, B0052:12, B0052:13 and B0052:1D Refer to Wiring Diagrams Cell 46 for schematic and connector information. Normal Operation and Fault Conditions The RCM monitors the passenger safety belt buckle switch circuits for the following faults: Open circuit Short to voltage Short to ground Current out of range Faulted passeng..

Rear Wheel Speed Sensor. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the retainer and pull the rear splash shield outward.

Disconnect the electrical connector and detach the wiring retainer.