Ford Fiesta: Seatbelt Systems / Seatbelt Systems - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Seatbelt Systems / Seatbelt Systems - Overview. Description and Operation

Overview - Safety Belt System

Each safety belt is a combination lap and shoulder belt (continuous loop), 3-point system. The continuous loop uses a common slip tongue and retractor.

Seatbelt Systems

Seatbelt Systems - System Operation and Component Description. Description and Operation

System Operation Emergency Locking Retractor (ELR) All retractors have an Emergency Locking Retractor (ELR) mode, which is a vehicle-sensitive feature designed to activate and lock the safety belt webbing during hard braking, cornering, or an impact of approximately 24 km/h (14...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Parking Aid Camera. Removal and Installation

Removal Remove the luggage compartment lid moulding. Refer to: Luggage Compartment Lid Moulding - 4-Door (501-08 Exterior Trim and Ornamentation, Removal and Installation). Refer to: Luggage Compartment Lid Moulding - 5-Door (501-08 Exterior Trim and Ornamentation, Removal and Installation)...

Ford Fiesta 2014 - 2019 Service Manual: Battery and Battery Charging Health and Safety Precautions. Description and Operation

WARNING: Batteries contain sulphuric acid, avoid contact with skin, eyes or clothing. Wear safety goggles when working near the battery to protect against possible splashing of the acid solution. WARNING: EYE CONTACT: If acid comes into contact with the eyes, flush immediately with plenty of running water for a minimum of 15 minutes...

Component Bleeding. General Procedures

Special Tool(s) / General Equipment

Master Cylinder Bleeding Set

Bleeding

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

Master Cylinder

NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system.

NOTE: Make sure the area around the master cylinder cap is clean and free of foreign material.

Remove the brake fluid reservoir cap.