Ford Fiesta: Body and Paint / Roof Sheet Metal Repairs
Special Tool(s) /
General Equipment
Resistance Spotwelding Equipment
Air Body Saw
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Removal
WARNING:
Before beginning any service procedure in this
manual, refer to Safety Warnings in section 100-00 General Information...
Special Tool(s) /
General Equipment
Resistance Spotwelding Equipment
Grinder
Knife
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055
-
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Flex..
Other information:
B00C5:11, B00C5:12, B00C5:13 and B00C5:1D
Refer to Wiring Diagrams Cell 46 for schematic and connector information.
Normal Operation and Fault Conditions
The RCM monitors the passenger seat position sensor circuits for the following faults:
Open circuit
Short to voltage
Short to ground
Current out of range
Faulted passenger se..
Sound Deadeners and Insulators
NOTICE:
Mastic material is made of a combustible material and should
be removed prior to carrying out welding procedures to the area. Heat
zones from welding near mastic may cause the mastic material to burn.
NOTICE:
Corrosion protection must be restored to the area after the
mastic material is applied. Corrosion protection products may be wax ..
Categories
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the brake shoes.
Refer to: Brake Shoes (206-02 Drum Brake, Removal and Installation).
Disconnect the brake tube fitting.
Torque:
159 lb.in (18 Nm)
Remove the bolt and wheel cylinder.
Torque:
106 lb.in (12 Nm)

Disconnect the brake shoe lever fitting and re
read more