Ford Fiesta: Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC/Touchscreen Display / Rear Door Speaker. Removal and Installation

Ford Fiesta 2014 - 2019 Service Manual / Information and Entertainment Systems / Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC/Touchscreen Display / Rear Door Speaker. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).

Remove the bolts and the rear door speaker.
- Disconnect the electrical connector.
  Torque: 18 lb.in (2 Nm)

Installation

To install, reverse the removal procedure.

Microphone. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: If the microphone is removed from the headliner, a new microphone must be installed...

SYNC Module [APIM]. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the FDIM . Refer to: Front Display Interface Module (FDIM) (415-00B Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC/Touchscreen Display, Removal and Installation)...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Air Deflector. Removal and Installation

Special Tool(s) / General Equipment Flat-Bladed Screwdriver Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: The roof opening panel glass must be in the fully open position...

Ford Fiesta 2014 - 2019 Service Manual: Footwell Air Discharge Temperature Sensor - Vehicles With: Electronic Automatic Temperature Control (EATC). Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the HVAC control module. Refer to: Heating, Ventilation and Air Conditioning (HVAC) Control Module (412-00 Climate Control System - General Information, Removal and Installation)...

Brake Master Cylinder. Removal and Installation

Removal

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

Remove the battery tray.
Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Disconnect the vacuum tube from the brake booster and detach the routing clip.