Ford Fiesta: Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC/Touchscreen Display / SYNC Module [APIM]. Removal and Installation
Removal
NOTE:
Removal steps in this procedure may contain installation details.
-
Remove the FDIM .
Refer to: Front Display Interface Module (FDIM)
(415-00B Information and Entertainment System - General Information -
Vehicles With: AM/FM/CD/SYNC/Touchscreen Display, Removal and
Installation).
-
Remove the screws and separate the APIM from the FDIM .
-
Disconnect the electrical connector.
Installation
-
To install, reverse the removal procedure.
-
If a new APIM is being installed, program the APIM to the correct software level.
Refer to: SYNC Module [APIM] Programming
(415-00B Information and Entertainment System - General Information -
Vehicles With: AM/FM/CD/SYNC/Touchscreen Display, General Procedures).
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear door trim panel.
Refer to: Rear Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...
Removal
Remove the FDIM .
Refer to: Front Display Interface Module (FDIM)
(415-00B Information and Entertainment System - General Information -
Vehicles With: AM/FM/CD/SYNC/Touchscreen Display, Removal and
Installation)...
Other information:
Special Tool(s) /
General Equipment
205-D015
(D80L-630-4)
Step Plate
205-D016
(D80L-630-5)
Step Plate
307-679Installer, Countershaft Needle BearingTKIT-2010D-FLMTKIT-2010D-ROW
308-416Remover/Installer, Thrust Washer Bearing CupTKIT-1999A-F/LTTKIT-1999A-FM/FLM
Hydraulic Press
Puller
Bearing Separator
Materials
..
Adjustment
WARNING:
Before beginning any service procedure in this
section, refer to Safety Warnings in section 100-00 General Information.
Failure to follow this instruction may result in serious personal
injury.
Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
If necessary, remove necessary tr..
Categories
Special Tool(s) /
General Equipment
Master Cylinder Bleeding Set
Bleeding
NOTICE:
If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
Master Cylinder
NOTE:
When a new brake master cylinder has been installed, it
should be primed to prevent air from entering the system.
NOTE:
Make sure the area around the master cylinder cap is clean and free of foreign material.
Remove the brake fluid reservoir cap.
read more