Ford Fiesta: Perimeter Anti-Theft Alarm / Perimeter Anti-Theft Alarm - Overview. Description and Operation
Overview
The perimeter alarm system deters unauthorized entry into the vehicle by sounding the horn and flashing all the turn signals. When an unauthorized entry occurs, the horn and the turn lamps activate.
The panic alarm operates similar to the perimeter alarm, but only
activates using the panic button on the RKE transmitter. For additional
information of the panic alarm function,
Refer to: Handles, Locks,
Latches and Entry Systems - System Operation and Component Description
(501-14 Handles, Locks, Latches and Entry Systems, Description and
Operation).
Perimeter Anti-Theft Alarm - System Operation and Component Description. Description and Operation
System Operation
System Diagram
Item
Description
1
BCM
2
Turn Signals
3
Horn
4
PATS Transceiver
5
Door Ajar Switches
6
Hood Ajar Switch
7
Liftgate/Luggage Compartment Lid Ajar Switch
8
IPC
9
Passive Key
10
RF Receiver
11
IKT
12
Ignition Switch
..
Other information:
Ford Fiesta 2014 - 2019 Service Manual: Front Door Window Regulator Motor. Removal and Installation
Removal NOTE: LH side shown, RH side similar. NOTE: Removal steps in this procedure may contain installation details. Remove the front door trim panel. Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation). Remove the front door window regulator and motor. Disconnect the front door window ..
Ford Fiesta 2014 - 2019 Service Manual: Evaporator. Removal and Installation
Removal NOTE: Removal steps in this procedure may contain installation details. Remove the instrument panel. Refer to: Instrument Panel (501-12 Instrument Panel and Console, Removal and Installation). Disconnect the electrical connectors, detach the wiring harness retainers and position aside the wiring harness. ..
Categories
- Manuals Home
- Ford Fiesta Service Manual (2014 - 2019)
- Camshafts. Removal and Installation
- Brake System
- Front Strut and Spring Assembly. Removal and Installation
- Engine
- Jacking and Lifting - Overview. Description and Operation
Ride Height Measurement. General Procedures
Special Tool(s) / General Equipment
Surface GaugeCheck
Ride Height Measurement - Front
NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.
Ride height = 2-3Measurement 2
Measurement 3
Use the General Equipment: Surface Gauge
