Ford Fiesta: Parking Aid - Vehicles With: Parking Aid Camera / Parking Aid - Overview. Description and Operation
Overview
The rear view camera system visually aids the driver while reversing or reverse parking the vehicle. The system has features that provide guideline overlays on the video image to assist the driver in aligning the vehicle with another stationary object or parking space. Vehicles equipped with the rear audible parking aid system have a visual park aid alert feature that visually highlights a zone in the video image where an object has been detected. The video camera system is controlled by the driver though the FDIM menus. Refer to the Owner's Literature for additional information on operating the video camera system features.
Parking Aid - System Operation and Component Description. Description and Operation
System Operation
System Diagram
Item
Description
1
Video camera
2
IPC
3
TCM
4
LIN
5
Video signal
6
Infotainment Controller Area Network (I-CAN)
7
HS-CAN
8
MS-CAN
9
PCM
10
Reversing lamp switch
11
Manual transm..
Other information:
Ford Fiesta 2014 - 2019 Service Manual: Fuel System Pressure Release. General Procedures
Pressure release NOTE: The fuel pump relay fuse is located in the BJB , location F11. Remove the fuel pump relay fuse. NOTE: It may take up to several minutes before the engine stalls. Start the engine and allow it to idle until the engine stalls. Crank the engine an additional 20 seconds to make sure the fuel system pressure has bee..
Ford Fiesta 2014 - 2019 Service Manual: Rear Bumper. Removal and Installation
Removal All vehicles NOTE: Removal steps in this procedure may contain installation details. Remove the rear bumper cover. Refer to: Rear Bumper Cover (501-19 Bumpers, Removal and Installation). 4-Door Remove the nuts and the rear bumper. Torque: 18..
Categories
- Manuals Home
- Ford Fiesta Service Manual (2014 - 2019)
- Engine. Assembly
- Cylinder Head. Removal and Installation
- Front Strut and Spring Assembly. Removal and Installation
- Service Information
- Engine System - General Information
Brake Master Cylinder. Removal and Installation
Removal
NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.
NOTE: Removal steps in this procedure may contain installation details.
All vehicles
Remove the battery tray.Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Disconnect the vacuum tube from the brake booster and detach the routing clip.
