Ford Fiesta Manuals

Ford Fiesta: General Information / Liquefied Petroleum Gas (LPG) and Compressed Natural Gas (CNG) Fuel Systems Health and Safety Precautions. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Service Information / General Information / Liquefied Petroleum Gas (LPG) and Compressed Natural Gas (CNG) Fuel Systems Health and Safety Precautions. Description and Operation

  WARNING: Service of Compressed Natural Gas (CNG) or Liquefied Petroleum Gas (LPG) vehicle systems is restricted to qualified personnel and authorized workshops. The required qualifications vary by region. Always observe local laws and legislative directives regarding CNG or LPG vehicle service. Failure to follow this instruction may result in serious personal injury or death.

  WARNING: Compressed Natural Gas (CNG) or Liquefied Petroleum Gas (LPG) is highly flammable and toxic when contained in unventilated work areas. Work in a dedicated area with good ventilation and no sources of ignition. Failure to follow these instructions may result in serious personal injury or death.

  WARNING: Liquefied Petroleum Gas (LPG) is capable of harming eyes or freezing skin. Always wear personal protection gear, including safety goggles and gloves to avoid contact with liquid gas. Failure to follow these instructions may result in serious personal injury.

  WARNING: Always observe local regulations regarding storage or indoor parking of Liquefied Petroleum Gas (LPG) vehicles. Do not park vehicles near sources of heat, ignition or unventilated open pits. Failure to follow these instructions may result in serious personal injury.

  WARNING: Liquefied Petroleum Gas (LPG) is heavier than air and will collect in low points in a building, such as drains or work pits. Never discharge a tank inside a building. If possible, tanks should be discharged beforehand by running the vehicle. Any discharge of gas must be done outside in well-ventilated flat areas. Failure to follow these instructions may result in the accumulation of combustible gas, which could cause personal injury or death in a fire or explosion.

  WARNING: Extreme heat such as paint drying ovens will cause an increase in Compressed Natural Gas (CNG) or Liquefied Petroleum Gas (LPG) fuel tank pressure. The fuel tank must be removed before using paint drying ovens with temperatures above 60° C. Failure to follow this instruction may result in a release of combustible gas, which could cause personal injury or death in a fire or explosion.

  WARNING: Liquefied Petroleum Gas (LPG) may present a personal health hazard if handled improperly. Always consult the LPG material safety information sheet before servicing a LPG vehicle. Failure to follow this instruction may result in serious personal injury or death.

    Wheel and Tire Health and Safety Precautions. Description and Operation

      WARNING: Never inflate a tire that has been run flat without first removing the tire from the wheel to inspect for damage. A damaged tire can fail during inflation...

    Diagnostic Methods. Description and Operation

    This document provides critical diagnostic knowledge required for successful repair outcomes. It identifies technical competencies expected by users of this manual...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Block Heater. Removal and Installation


    Materials Name Specification Motorcraft® Metal Surface Prep WipesZC-31-B -  Removal NOTE: Removal steps in this procedure may contain installation details. Drain the cooling system. Refer to: Engine Cooling System Draining, Vacuum Filling and Bleeding (303-03B Engine Cooling - 1...

    Ford Fiesta 2014 - 2019 Service Manual: Evaporator Outlet Line - 1.6L EcoBoost (132kW/180PS) – Sigma. Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the air cleaner outlet pipe. Refer to: Air Cleaner Outlet Pipe (303-12B Intake Air Distribution and Filtering - 1.6L EcoBoost (132kW/180PS) – Sigma, Removal and Installation)...

    Categories

    Rear Wheel Speed Sensor. Removal and Installation

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    Remove the retainer and pull the rear splash shield outward.
    Disconnect the electrical connector and detach the wiring retainer.

    read more

    Copyright © 2026 www.fofiesta7.com