Ford Fiesta Manuals

Ford Fiesta: Interior Lighting / Interior Lighting - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Lighting / Interior Lighting / Interior Lighting - Overview. Description and Operation

Overview

The interior lighting system consists of:

  • Courtesy lamps
  • Demand lamps
  • Ambient lighting (if equipped)

The courtesy lamps subsystem consists of:

  • Interior lamps (roof mounted)
  • Door ajar switches (integrated into the door latches)
  • Courtesy lamp switch (integrated into the front and rear interior lamp)
  • BCM

The courtesy lamps provide illumination to the interior of the vehicle when entering or exiting the vehicle or when requested using the courtesy lamp switch located on the front and rear interior lamps.

The demand lamps subsystem consists of:

  • Interior lamps (map lamps)
  • Cargo area lamp
  • BCM

The demand lamps provide illumination to specific areas within the vehicle when needed.

The BCM energizes the battery saver output supply voltage to the demand lamps when the battery saver feature is not active.

The ambient lighting subsystem consists of:

  • Ambient lighting Light Emitting Diodes (LEDs)
  • Ambient lighting module
  • Ambient lighting switch
  • BCM

The ambient lighting provides aesthetically colored illumination to the center console cup holders, the instrument panel and the front and rear footwells for illuminated entry or when the ignition is in RUN with the parking lamps on. The ambient lighting color is controlled and can be switched off using the ambient lighting switch.

    Interior Lighting

    ..

    Interior Lighting - System Operation and Component Description. Description and Operation

    System Operation System Diagram Network Message Chart   BCM Network Input Messages Broadcast Message Originating Module Message Purpose RKE data RFA module Provides information regarding the RKE system for the BCM to activate or deactivate the illuminated e..

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Blower Motor Speed Control - Vehicles With: Electronic Automatic Temperature Control (EATC). Removal and Installation


    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the push pin, release the clips and remove the RH floor console trim panel. Disconnect the electrical connectors, remove the retainers and the blower motor speed control. Installation To inst..

    Ford Fiesta 2014 - 2019 Service Manual: Information and Entertainment System - System Operation and Component Description. Description and Operation


    System Operation System Diagram Network Message Chart   ACM Module Network Input Messages Broadcast Message Originating Module Message Purpose Audio button state   FCDIM Used to indicate when a button is pressed on the FCIM . Audio source reques..

    Categories

    Brake Master Cylinder. Removal and Installation

    Removal

    NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

    NOTE: Removal steps in this procedure may contain installation details.

    All vehicles

    Remove the battery tray.
    Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
    Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
    Disconnect the vacuum tube from the brake booster and detach the routing clip.

    read more

    Copyright © 2025 www.fofiesta7.com