Ford Fiesta: Interior Trim and Ornamentation / Headliner - Lowering - 4-Door. Removal and Installation
-
On both sides.
Remove the retainers and the sun visor.
-
On both sides.
Remove the retainer and the sun visor clip.
-
On both sides, remove the A-pillar trim panel.
Refer to: A-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
On both sides, remove the B-pillar trim panel.
Refer to: B-Pillar Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Release the clips, disconnect the electrical connectors and remove the overhead console.
-
On both sides, remove the upper C-pillar trim panel.
Refer to: C-Pillar Upper Trim Panel - 4-Door (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Release the clips and remove the cover.
-
Remove the retainers.
-
On both sides.
On the RH side, disconnect the headliner wire harness electrical connector.
-
If equipped.
Remove the roof opening panel seal.
-
-
If equipped.
Remove cover and disconnect the electrical connector.
-
If equipped.
Disconnect the rear view mirror electrical connector.
-
NOTE:
Headliner removed for clarity.
If equipped.
Disconnect the roof opening panel motor electrical connector.
-
Position the rear seat backrests up. .
-
Position the driver side front seat.
-
Position the seat in the full forward position.
-
Position the seat in the full reclined position.
-
Lower the headliner.
Removal
NOTE:
RH side shown, LH side similar.
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
To avoid damage to the trim panels, remove any retaining
clips from the body and attach them to the trim panels before
installing...
Materials
Name
Specification
3M™ Super-Fast Repair Adhesive04747
-
Removal
On both sides.
Remove the retainers and the sun visor...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
NOTE:
If equipped with push button start the keys need to be programmed into
the new RFA module during ignition off. Once the push button start keys
have been programmed into the new RFA module, the ignition must be
changed to the ON mode in order to carry out the PATS parameter reset
procedure wit..
Removal
NOTICE:
Suspension fasteners are critical parts that affect
performance of vital components and systems. Failure of these fasteners
may result in major service expense. Use the same or equivalent parts if
replacement is necessary. Do not use a replacement part of lesser
quality or substitute design. Tighten fasteners as specified.
Remove the brake disc.
Refer..
Categories
Preliminary Inspection
Verify the customer concern by carrying out a road test on a
smooth road. If any vibrations are apparent, Refer to the Symptom
Chart: NVH.
To maximize tire performance, inspect for signs of incorrect
inflation and uneven wear, which may indicate a need for balancing,
rotation or front suspension alignment.
Correct tire pressure and driving techniques have an
important influence on tire life. Heavy cornering, excessively rapid
acceleration and unnecessary sharp braking increase tire wear.
Correct
tire pressure and driving techniques have an important influence on
tire life. Heavy cornering, exce
read more