Ford Fiesta: Evaporative Emissions - 1.6L EcoBoost (132kW/180PS) – Sigma / Evaporative Emissions. Diagnosis and Testing

Ford Fiesta 2014 - 2019 Service Manual / Engine / Evaporative Emissions - 1.6L EcoBoost (132kW/180PS) – Sigma / Evaporative Emissions. Diagnosis and Testing

Engine Diagnostic Information

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these,
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).

For PCM DTC ,
REFER to: Electronic Engine Controls (303-14B Electronic Engine Controls - 1.6L EcoBoost (132kW/180PS) – Sigma, Diagnosis and Testing).

For driveability symptoms without DTC , Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 3, Symptom Charts.

Evaporative Emissions - System Operation and Component Description. Description and Operation

S..

Evaporative Emission System Leak Test. General Procedures

Activation Disconnect the vapor tube-to-EVAP canister purge valve quick connect coupling (engine side). Refer to: Quick Release Coupling (310-00B Fuel System - General Information - 1...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Rear Suspension - Component Location. Description and Operation

NOTE: Base model shown, ST similar. Item Description 1 Shock absorber 2 Spring 3 Twist-beam rear axle 4 Twist-beam rear axle receiver bearing ..

Ford Fiesta 2014 - 2019 Service Manual: Luggage Compartment Lid Moulding - 4-Door. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the clips and the liftgate trim panel. If equipped. Disconnect the electrical connector and position aside the wiring harness. NOTE: A new lower applique must be installed. Release th..

Axle. Removal and Installation

Special Tool(s) / General Equipment

Flat Headed Screw Driver Transmission Jack Vehicle/Axle Stands

Removal

NOTICE: Suspension fasteners are critical parts that affect performance of vital components and systems. Failure of these fasteners may result in major service expense. Use the same or equivalent parts if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Tighten fasteners as specified.

Remove the floor console.
Refer to: Floor Console (501-12 Instrum