Ford Fiesta: Engine Ignition - 1.6L EcoBoost (132kW/180PS) – Sigma / Engine Ignition. Diagnosis and Testing

Ford Fiesta 2014 - 2019 Service Manual / Engine / Engine Ignition - 1.6L EcoBoost (132kW/180PS) – Sigma / Engine Ignition. Diagnosis and Testing

General Equipment

Ford diagnostic equipment

Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these,
REFER to: Diagnostic Methods (100-00 General Information, Description and Operation).

For PCM DTC ,
REFER to: Electronic Engine Controls (303-14B Electronic Engine Controls - 1.6L EcoBoost (132kW/180PS) – Sigma, Diagnosis and Testing).
MIL Code List.

For driveability symptoms without DTC , Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. section 3 Symptom Charts.

Engine Ignition - System Operation and Component Description. Description and Operation

System Operation For System Operation, Refer to Powertrain Control/Emissions Diagnosis (PC/ED) manual. See Section 1 Description and Operation...

Ignition Coil-On-Plug. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the engine appearance cover. Disconnect the crank case ventilation tube quick release coupling...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Audio Unit Antenna Cable. Removal and Installation

Special Tool(s) / General Equipment Interior Trim Remover Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: The AM / FM /Satellite radio antenna cables are part of the vehicle wiring harness...

Ford Fiesta 2014 - 2019 Service Manual: Engine Cooling System Draining, Vacuum Filling and Bleeding. General Procedures

Special Tool(s) / General Equipment ROB75240Coolant/Battery Refractometer (Fahrenheit) Hose Clamp Remover/Installer Fluid Container Cooling System Vacuum Tester and Refiller Materials Name Specification Motorcraft® Orange Prediluted Antifreeze/CoolantVC-3DIL-B WSS-M97B44-D2 Motorcraft® Orange Concentrated Antifreeze/Co..

Brake Master Cylinder. Removal and Installation

Removal

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Removal steps in this procedure may contain installation details.

All vehicles

Remove the battery tray.
Refer to: Battery Tray - 1.6L Duratec-16V Ti-VCT (88kW/120PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Refer to: Battery Tray - 1.6L EcoBoost (132kW/180PS) – Sigma (414-01 Battery, Mounting and Cables, Removal and Installation).
Disconnect the vacuum tube from the brake booster and detach the routing clip.