Ford Fiesta: Handles, Locks, Latches and Entry Systems / Staged Unlock Programming. General Procedures

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Handles, Locks, Latches and Entry Systems / Staged Unlock Programming. General Procedures

Activation

With the ignition in OFF, press the LOCK and UNLOCK buttons on the RKE transmitter simultaneously for 4 seconds.

The turn signals flash twice to indicate the mode change.

Repeat these steps to enable/disable the staged unlocking feature.

Remote Keyless Entry (RKE) Transmitter Programming. General Procedures

Programming NOTE: All RKE transmitters must be programmed at the same time. Entering the programming mode erases all previously programmed RKE transmitters (Integrated Keyhead Transmitters (IKTs) and key fobs)...

Exterior Front Door Handle. Removal and Installation

Removal NOTE: LH side shown, RH side similar. Remove the access plug and loosen the exterior front door handle retaining screw...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Roof Opening Panel Frame. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the headliner. Refer to: Headliner - 4-Door (501-05 Interior Trim and Ornamentation, Removal and Installation). Refer to: Headliner - 5-Door (501-05 Interior Trim and Ornamentation, Removal and Installation)...

Ford Fiesta 2014 - 2019 Service Manual: Camshafts. Removal and Installation

Special Tool(s) / General Equipment 303-1532Installer, Camshaft SealTKIT-2010B-FLMTKIT-2010B-ROW 303-393-02Adapter for 303-393TKIT-2012A-FLTKIT-2012A-ROW 303-393ALocking Tool, FlywheelTKIT-2012A-FLTKIT-2012A-ROW 303-409 (T92C-6700-CH) Remover, Crankshaft SealTKIT-1992-FH/FMH/FLMHTKIT-1993-LMH/MH 303-748Locking Tool, CrankshaftTKIT-2010B-F..

Component Bleeding. General Procedures

Special Tool(s) / General Equipment

Master Cylinder Bleeding Set

Bleeding

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

Master Cylinder

NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system.

NOTE: Make sure the area around the master cylinder cap is clean and free of foreign material.

Remove the brake fluid reservoir cap.