Ford Fiesta: Brake System - General Information / Specifications

Ford Fiesta 2014 - 2019 Service Manual / Brake System / Brake System - General Information / Specifications

Lubricants, Fluids, Sealers and Adhesives

	Specifications
Motorcraft® DOT 4 LV High Performance Motor Vehicle Brake Fluid / PM-20	WSS-M6C65-A2 and ISO 4925 Class 6

Torque Specifications

Item	Nm	lb-ft	lb-in
Front caliper bleeder screw	10	-	89
Rear caliper bleeder screw	12	-	106
Rear wheel cylinder bleeder screw	6	-	54
Master cylinder brake tube fittings	18	-	155

General Specifications

Item	Specification
Front brake disc minimum thickness	0.827 in ( 21 mm)
Rear brake disc minimum thickness	0.354 in ( 9 mm)
Brake drum maximum diameter	7.933 in ( 201.5 mm)
Brake pad minimum thickness	0.118 in ( 3 mm)
Brake shoe minimum thickness	0.039 in ( 1 mm)
Brake pad maximum taper wear (in any direction)	0.118 in ( 3 mm)

Brake System - General Information

Brake System. Diagnosis and Testing

Symptom Chart(s) Symptom Chart: Brake System Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: Auxiliary Climate Control. Diagnosis and Testing

DTC Chart: Heating, Ventilation And Air Conditioning (HVAC) Control Module Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. For information about these practices, REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...

Ford Fiesta 2014 - 2019 Service Manual: Battery Charging. General Procedures

Charging WARNING: Before beginning any service procedure in this section, refer to Safety Warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury. NOTE: Batteries will discharge due to normal parasitic key off-loads when the vehicle is on a dealer lot or parked by the customer for an extended period of..

Front Strut and Spring Assembly. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

NOTE: This step is only necessary when installing a new component to the left-hand side.

Remove the nuts and position aside the remote brake fluid reservoir.
Torque: 62 lb.in (7 Nm)

Remove the strut and spring assembly upper mount nuts.
Torque: 22 lb.ft (30 Nm)