Ford Fiesta: Passive Anti-Theft System (PATS) - Vehicles With: Keyless Entry and Push Button Start / Passive Anti-Theft System (PATS) - Overview. Description and Operation

Ford Fiesta 2014 - 2019 Service Manual / Electronic Feature Group / Passive Anti-Theft System (PATS) - Vehicles With: Keyless Entry and Push Button Start / Passive Anti-Theft System (PATS) - Overview. Description and Operation

Overview

The PATS deters the vehicle from theft by preventing the vehicle from starting unless a programmed key is detected inside the vehicle when the START/STOP button is pressed.

The PATS does not disable an already running vehicle.

Passive Anti-Theft System (PATS) - Vehicles With: Keyless Entry and Push Button Start

Passive Anti-Theft System (PATS) - System Operation and Component Description. Description and Operation

System Operation System Diagram Item Description 1 RFA Module 2 Passive Key 3 Start/Stop Switch 4 Smart Keyless Entry Relays 5 PATS Antennas 6 PATS Transceiver 7 RF Receiver 8 PATS Enable 9 PCM Network Message Chart RFA Module Network Input Me..

Other information:

Ford Fiesta 2014 - 2019 Service Manual: SYNC Module [APIM]. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. Remove the FDIM . Refer to: Front Display Interface Module (FDIM) (415-00B Information and Entertainment System - General Information - Vehicles With: AM/FM/CD/SYNC/Touchscreen Display, Removal and Installation). Remove the screws and separate the APIM from the FDIM ...

Ford Fiesta 2014 - 2019 Service Manual: Door Latch Lubrication. General Procedures

Special Tool(s) / General Equipment Flat-Bladed Screwdriver Materials Name Specification Motorcraft® Multi-Purpose Grease SprayXL-5-A ESB-M1C93-B Activation NOTE: Typical left front door shown, others similar. Open the door. Using a flat blade screwdriver, fully close the latch..

Component Bleeding. General Procedures

Special Tool(s) / General Equipment

Master Cylinder Bleeding Set

Bleeding

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

Master Cylinder

NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system.

NOTE: Make sure the area around the master cylinder cap is clean and free of foreign material.

Remove the brake fluid reservoir cap.