Ford Fiesta Manuals

Ford Fiesta: Exterior Trim and Ornamentation / Luggage Compartment Lid Moulding - 4-Door. Removal and Installation

Ford Fiesta 2014 - 2019 Service Manual / Body and Paint / Exterior Trim and Ornamentation / Luggage Compartment Lid Moulding - 4-Door. Removal and Installation

Removal

NOTE: Removal steps in this procedure may contain installation details.

  1. Remove the clips and the liftgate trim panel.
  1. If equipped.
    Disconnect the electrical connector and position aside the wiring harness.
  1. NOTE: A new lower applique must be installed.

    Release the clips and remove the lower applique.
  1. Remove the bolts.
    Torque: 13 lb.in (1.5 Nm)
  1. Remove the luggage compartment lid moulding.

Installation

  1. To install, reverse the removal procedure.

    Rear Spoiler - 5-Door. Removal and Installation

    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the high mounted stoplamp. Refer to: High Mounted Stoplamp (417-01 Exterior Lighting, Removal and Installation)...

    Luggage Compartment Lid Moulding - 5-Door. Removal and Installation

    Removal NOTE: Removal steps in this procedure may contain installation details. Remove the liftgate trim panel. Refer to: Liftgate Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

    Other information:

    Ford Fiesta 2014 - 2019 Service Manual: Exhaust Manifold Cleaning and Inspection. General Procedures


    Special Tool(s) / General Equipment Feeler Gauge Cleaning Clean the exhaust manifold using a suitable solvent. Use a plastic scraping tool to clean the gasket sealing surfaces. Inspection NOTE: New exhaust manifold gaskets, studs, nuts and/or bolts must be installed when an exhaust manifold is serviced...

    Ford Fiesta 2014 - 2019 Service Manual: Warning Chimes - System Operation and Component Description. Description and Operation


    System Operation System Diagram Item Description 1 HS-CAN 2 MS-CAN 3 Belt-Minder® chime 4 Door ajar chime 5 Headlamps on chime 6 Key-in-ignition chime 7 Parking brake chime 8 Safety belt chime 9 Turn signal on tick-tock tone 10 Ignition switch (without..

    Categories

    Ride Height Measurement. General Procedures

    Special Tool(s) / General Equipment

    Surface Gauge

    Check

    Ride Height Measurement - Front

    NOTE: Make sure that the vehicle is positioned on a flat, level surface and the tires are inflated to the correct pressure. Vehicle should have a full tank of fuel.

    Ride height = 2-3
    Measurement 2
    Measurement 3
    Use the General Equipment: Surface Gauge

    read more

    Copyright © 2026 www.fofiesta7.com