Ford Fiesta: Drum Brake / Brake Shoe Adjustment. General Procedures

Ford Fiesta 2014 - 2019 Service Manual / Brake System / Drum Brake / Brake Shoe Adjustment. General Procedures

Adjustment

NOTE: The brake shoes and parking brake cables must both be adjusted to assure correct rear drum brake and parking brake system operation.

Refer to: Parking Brake Cable Adjustment (206-05 Parking Brake and Actuation, General Procedures).

Drum Brake

Brake Drum. Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. WARNING: Before beginning any service procedure in this manual, refer to health and safety warnings in section 100-00 General Information...

Other information:

Ford Fiesta 2014 - 2019 Service Manual: A-Pillar Outer Panel. Removal and Installation

Special Tool(s) / General Equipment Resistance Spotwelding Equipment Hot Air Gun Air Body Saw 8 mm Drill Bit MIG/MAG Welding Equipment Spot Weld Drill Bit Materials Name Specification Metal Bonding AdhesiveTA-1, TA-1-B, 3M™ 08115, LORD Fusor® 108B, Henkel Teroson EP 5055 - Seam SealerTA-2-B, 3M™ 08308, ..

Ford Fiesta 2014 - 2019 Service Manual: Hydraulic Control Unit (HCU). Removal and Installation

Removal NOTE: Removal steps in this procedure may contain installation details. NOTE: The HCU and ABS module are serviced as an assembly. NOTE: The PMI process must begin with the current ABS module installed. If the current ABS module does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair. If installing a ne..

Component Bleeding. General Procedures

Special Tool(s) / General Equipment

Master Cylinder Bleeding Set

Bleeding

NOTICE: If the fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

Master Cylinder

NOTE: When a new brake master cylinder has been installed, it should be primed to prevent air from entering the system.

NOTE: Make sure the area around the master cylinder cap is clean and free of foreign material.

Remove the brake fluid reservoir cap.